Older automag valve, leaks from back adjuster hole. No other leaks. Serial is CF07429. Has 8 hole mode in reg body. Aired this up and as I turn the adjuster screw up it starts leaking out the reg body. Likely a bad pressure relief (brass bodied piece, cant remember the name) that has a bad urethane seal in it. Includes macroline fitting on side. Has .220 powertube spacer in it. Since no paint was shot I'm not sure on chronograph reading. If planning on using will eventually need a rebuild since this is a used valve. Tested on 1-20-2015. Has an ANS phase II venturi bolt. Has red loctited powertube, not welded so can be separated.